Program Edit Mode
The DSP Control (DSP CTL) Page
3-54
Subpage Parameters
The right-hand side of the DSP CTL page shows a subpage with fine adjust and hard-wired
modulation parameters for the selected function-parameter. To access the parameters on the
subpage, highlight the function-parameter you wish to edit, and then press the > button
to move the cursor into the subpage. The label of a function-parameter depends on its
corresponding function-block in the current layer’s algorithm.
Fine
Use the Fine parameter to make fine adjustments to the selected function-parameter. Not all
function-parameters have a Fine parameter.
The default Pitch function-parameter has two fine adjust parameters. The Fine parameter
changes the pitch in cents (100ths of a semitone). The Hz parameter changes pitch according
to its frequency in Hertz (cycles per second).
Key Tracking
Use the KeyTrk parameter to modulate the selected function-parameter based on the MIDI
note number of each note played.
Positive KeyTrk values will progressively increase modulation depth for each note played
above middle C, and progressively decrease modulation depth for notes played below
middle C. For example, with a positive KeyTrk value, playing middle C causes no change
in modulation depth, playing each key further above middle C increases the modulation
depth by the KeyTrk amount, and playing each key further below middle C decreases the
modulation depth by the KeyTrk amount.
Negative KeyTrk values will progressively decrease modulation depth for each note played
above middle C, and progressively increase modulation depth for notes played below
middle C. For example, with a negative KeyTrk value, playing middle C causes no change
in modulation depth, playing each key further above middle C decreases the modulation
depth by the KeyTrk amount, and playing each key further below middle C increases the
modulation depth by the KeyTrk amount.
For the default Pitch function-parameter, the value set for the KeyTrk parameter on the DSP
CTL page is added to the value set for the key tracking parameter on the KEYMAP page.
Velocity Tracking
Use the VelTrk parameter to modulate the selected function-parameter based on the MIDI
velocity of each note played.
Positive VelTrk values will progressively increase modulation depth for higher velocities. For
example, with a positive VelTrk value, playing a velocity of 0 causes no change in modulation
depth, playing each velocity further above 0 increases the modulation depth by the VelTrk
amount.
Содержание Flash Play PC4
Страница 1: ... It s the sound Part Number 910587 002 Rev B ...
Страница 9: ... ix MIDI Implementation A 1 Specifications B 1 Index I 1 ...
Страница 289: ... 8 40 ...
Страница 328: ... 10 7 ...