Multi Edit Mode
ARP Page
7-29
Mod Override
The Mod Override parameter allows you to select a controller or modulation source which
will control the send level or dry/wet amount for the Aux 1 or Aux 2 Chain. Selecting a Mod
Override will disable any Aux Mod controller or modulation source that was assigned in the
Program of the Aux FX Channel.
If you select a MIDI controller for the Mod Override (entries 1 through 95 in the Mod
Override list), you must select the same MIDI controller number in the “Destination” field
for the desired controller on the Multi Controls page. This must be done for each Zone that
you wish to apply the Mod override controller. The Multi Controls page allows you to set
entry/exit values as well as scaling and offset values for the Mod Override controller.
When the Mod Override parameter is selected, you can quickly select one of the PC4’s
physical controllers by holding the Enter button and moving the controller.
Output
This parameter specifies the physical audio output pair for the corresponding Aux Chain’s
output. The settings A and B refer respectively to the A and B physical audio outputs of the
PC4. Setting Output to Auto uses the output pair specified in the program on the specified
Aux Effects channel.
ARP Page
The Arpeggiator in Multi Mode is very similar to the Program Mode arpeggiator. See
The Arpeggiator (ARP) Page on page 3-21
of the Program Edit Mode Chapter for a full
description of each arpeggiator parameter.
Содержание Flash Play PC4
Страница 1: ... It s the sound Part Number 910587 002 Rev B ...
Страница 9: ... ix MIDI Implementation A 1 Specifications B 1 Index I 1 ...
Страница 289: ... 8 40 ...
Страница 328: ... 10 7 ...