Kurzweil Flash Play PC4, Руководство музыканта

Страница: 216 / 335

Multi Edit Mode
MAIN Page
7-10
Offset and Scale work together. If scaling takes the velocity out of the ballpark — for
example, you want to set it to 300% but that puts all of your notes at maximum velocity —
using a negative offset, say around -60, can make it possible to still play at different volumes,
although your curve will still be a lot steeper than normal. If you use a negative scaling,
then you must use an offset: otherwise all of your velocities will end up as zeroes (well, ones
actually, since a MIDI note-on with velocity zero is interpreted by some modules as a note-
off message). So to get true inverse scaling (that is, minus 100%), you must set an offset of
127 to get the full range of velocities. Setting the offset to 127 and the scale to -100% (which
is the same as the reverse linear curve).
Note: Offset and Scale only affect incoming MIDI velocities; these parameters don’t change
Velocity Tracking in the programs themselves. Therefore, programs which have low VelTrk
values may respond only subtly to Offset and Scale, or not at all.
Velocity Curve
The Velocity Curve parameter lets you taper the velocity response. The default setting is
Linear , which means that the output velocity changes directly proportionally to the played
velocity.
Expand
produces a curve that is less steep than the linear curve at keystrike velocities below
64, and steeper than the linear curve at keystrike velocities above 64. In other words, when
you’re playing softly, you’ll notice velocity differences less than with a linear curve, while
when you’re playing hard, you’ll notice velocity differences more.
Compress
produces a velocity curve that is the opposite of the expanded curve—that is,
you’ll notice velocity differences more when you’re playing softly than when you’re playing
hard.
Crossfade
is designed to be used in tandem with the Reverse Crossfade curve, enabling you
to perform smooth crossfades between different programs.
Bump
tapers velocity response to resemble a bell curve, so that notes are loudest when your
keystrike velocity is 64. Notes get softer as the keystrike velocity approaches 0 or 127.
The next four velocity curves are Reverse Linear (Rvrs Linear), Reverse Expand (Rvrs
Expand ), Reverse Compress (Rvrs Compress), and Reverse Crossfade (Rvrs Crossfade).
These taper velocity in reverse of the five curves we just covered. For example, Reverse
Linear’s response is such that striking a key harder will produce a lower volume, striking it
softer will produce a higher volume, and so on. This provides a convenient way to achieve
negative scaling, by letting you set one parameter instead of two.
Low Velocity, High Velocity
Low Velocity and High Velocity set the minimum and maximum velocity limits that the
current Zone transmits.