KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 36 / 64

36
4
1
2
The hydraulic connection to the tractor may be made in one of three ways:
1. Single-acting distributor pressure and direct return to tank.
2. Double-acting distributor pressure and return to second orifice of the same distributor (beware
of direction of oil flow)
3. Pressure on line to be followed from tractor distributor and return to tank.
Connect the hoses. Make sure that the hoses cannot catch while in operation.
If the machine distributor is connected to the original tractor distributor, activate the relevant handle on
the tractor distributor to pressurise the hydraulic circuit (beware of direction of oil flow).
LIGHTING
Keep all lighting clean and in good working order. Repair them immediately.
Before taking out onto public roads, check that all lighting is in good working
order.
Plug the lighting equipment into the standardised 7-pin socket at the rear of the tractor.
CONTROL HARNESS SUPPLY
- Machine with remote control cables.
- The electric power cable (2) is not supplied mounted.
- Connect this cable to the + and - terminals on your tractor battery
(brown wire to + and blue wire to -).
- Then connect the socket (1) to the power cable (2) to activate
the controls. The power cable is equipped with a 15 Amp fuse
(4) – part n° A7040915.
If you use a second tractor, ask for a second power cable (2) – part n° A7040064.
For a constant, even power supply to the machine, the electric power cable must be connected to the
battery. The power cable socket (2) is best fitted onto the lower crossbar in the rear opening of the
cab.
When mounting the power cable on the tractor, pay attention to the routing of the wire. Beware of
shearing, burning on the exhaust pipe, etc.