KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 46 / 64

46
ADJUSTING THE LIMIT OF TRAVEL SENSOR
USING A BELT-DRIVEN BEATER BAR
1. Check that there is no pressure on the silage or bale against the beater bar. If this is the case,
release the grab slightly from the bale.
2. A height of approximately 50 cm between the sill wear plate and the ground is recommended.
3). Set the delivery chute according to the product to be distributed (refer to “Starting Up”).
4. Select the turbine speed.
5. Start the PTO.
6. Check that the conveyor forward speed is set to zero.
7. Engage the beater bar.
8. Latch the conveyor switch in forward motion (see previous page).
9. Select the conveyor speed (depending on the tractor output and the nature of the bale).
10. In the course of distribution, the grab can be moved slightly forward to keep the product in contact
with the beater bar.
11. Unfold the cover at the end of distribution if product is being projected out of the machine.
12. At the end of distribution, disengage the beater bar, bring the arm and grab fully in, stop the PTO,
close the chute and switch off the engine.
CLUTCH CONNECTING ROD
A5250636
STOP
M4X40 HEX SOCKET HD SCREW
M4 NUT
POSITION SWITCH
A7040714
POSITION SWITCH ADJUSTMENT
- In the engaged position: 2 mm
clearance between stop and switch
in “full in” position.