KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 9 / 64

9
15. When the universal drive shaft has been disconnected from the tractor PTO, refit the protective
cap.
16. Any damaged PTO and universal drive shaft guards must be replaced immediately.
17. Beware! Only use the machine with a PTO speed of 540 rpm.
18. Pay attention not to damage the drive assembly during lifting operations..
HYDRAULIC CIRCUIT
1. Beware! The hydraulic circuit is under pressure.
2. On fitting the hydraulic motors and rams, make sure that the circuits are connected correctly
according to the manufacturer’s instructions.
3. Check the hydraulic hoses regularly! Damaged or worn hoses must be replaced immediately.
When replacing hydraulic hoses, make sure that only hoses with the characteristics and quality
specified by the manufacturer of the machine are used.
4. When tracing a leak, take appropriate precautions to avoid an accident.
5. Any liquid under pressure, especially hydraulic fluid, can pierce the skin and cause serious injury.
In case of injury, seek medical advice immediately. There is a risk of infection.
6. Before carrying out any operations on the hydraulic circuit, lower the machine, fully retract the
arm and grab ram rods, switch off the engine and circuit pressure and remove the key from the
ignition.
7. Never change the order of commands or the direction of movements on the hydraulic circuit.
8. In the case of an auxiliary unit, the gear selector lever must be in neutral.
9. Check that all safety valves on the body lift rams are working properly.
ELECTRICAL CIRCUIT
Before connecting up the machine’s electrical circuit :
- check the state of the electrical circuit (harnesses, fuses and lighting);
- check the state and cleanness of the power socket.
TYRES
1. Before carrying out any operations on the tyres, make sure the trailer is perfectly stable and
cannot move accidentally (fit chocks).
2. Wheels and tyres must only be fitted, removed and repaired by persons with the expertise required
to do so and possessing the appropriate regulatory tools.
3. Check tyre pressure regularly. Inflate to the pressure indicated by the manufacturer.
4. Check wheel nut tightness regularly.