KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 34 / 64

34
TRANSMISSION
Working Parts (PTO and universal drive shafts)
Carefully read the instructions supplied with the transmission.
1. Only use universal drive shafts supplied with the machine or recommended by the manufacturer.
2. The PTO and universal drive shaft guards must always be fitted and in good condition.
3. Make sure that there is correct tube overlap on the universal drive shafts, both in the working
position and the transport position. Adjust the length of the tubes if necessary.
4. Before connecting or disconnecting a universal drive shaft, disengage the PTO, switch off the
engine and remove the key from the ignition.
5. Always make sure that the universal drive shafts are properly fitted and secured.
6. Make sure that the universal drive shaft guards are prevented from rotating by the special chains.
7. Before engaging the PTO, make sure that the speed setting and direction of rotation comply with
the manufacturer’s instructions.
8. Before engaging the PTO, make sure that there are no persons or animals near the machine.
9. Never engage the PTO with the tractor engine switched off.
10. Disengage the PTO whenever the universal drive shaft angle limits indicated by the manufacturer
are in danger of being exceeded.
11. Beware! After disengaging the PTO, moving parts continue to rotate for a few seconds. Keep
away until they have stopped.
12. On unhitching the machine, rest the universal drive shafts on the special supports.
13. When the universal drive shaft has been disconnected from the tractor PTO, refit the protective
cap.
14. Any damaged PTO and universal drive shaft guards must be replaced immediately.
15. Beware! Only use the machine with a PTO speed of 540 min -1 .
16. Any action on the lift function may damage the transmission.
17. Check that the overload clutch is working properly. After a period of inactivity, disassemble and
clean the clutch (see the transmission instructions supplied with the machine).