KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 35 / 64

35
UNIVERSAL DRIVE
- At maximum extension, there must be a tube overlap of A = 330 mm (Fig. 4).
- At maximum overlap (with the drive shaft compressed), there must be a safety gap of B = 20 mm to
prevent the tubes striking the jaws (Fig. 4).
- If the above conditions are not met, shorten the guards (1) and the tubes (2) by the same length (X)
(Fig. 5).
- Round off and clean the tubes and grease the inside of the outer tube.
- Always make sure that the universal drive shafts are properly fitted and secured.
- Any damaged PTO and universal drive shaft guards must be replaced immediately.
Make sure that the drive guards are properly fitted and prevented from rotating
by the special chains. Replace any damaged guards immediately.
Consult the operating and maintenance instructions enclosed with the drive
shaft.
CONNECTIONS
Hydraulic
(Machines not equipped with an auxiliary unit)
The machine requires a double-acting hydraulic distributor with an independent lift function. The
machine’s hydraulic circuit operates at a maximum pressure of 180 bar.
The pressure hose is equipped with a female push-pull coupler (ISO 7241).
The return hose is equipped with a female push-pull coupler (ISO 7241).
Connect the distributor supply hoses to the tractor. The pressure hose (P) is identified by a white
arrow on a red background, with the arrow pointing away from the tractor towards the distributor. The
return hose (T) is identified by a white arrow on a blue background, with the arrow pointing away from
the distributor towards the tractor.
Fig. 4 Fig. 5