KUHN BELT-DRIVEN MINOTOR 3060, Руководство оператора

Страница: 43 / 64

43
Straw bedding
- The fan should be set to 540 min -1 .
- Engage the tractor PTO.
- Start up the tractor hydraulics and bring up to nominal speed.
- Position the chute so that the straw is projected where required.
- For even spreading, the bale must remain in permanent contact with the beater bar without over-
jamming it with the claw. Raise the machine slightly at the rear to prevent the bale from being
projected back by the rotation of the beater bar.
- The product output is adjusted by:
. the tractor engine speed (which determines the hydraulic output and the speed of rotation of
the PTO),
. the forward speed of the tractor,
. the forward speed of the conveyor (to adjust, refer to “Description of Controls”).
- To distribute the product, start up the beater bar and conveyor (refer to “Description of Controls”).
- To stop distribution instantaneously (posts, various obstacles, etc.), stop the beater bar and conveyor
rotation.
- At regular intervals, bring the bale into contact with the beater bar by pulling in the grab.
In the event of a beater bar blockage, switch the beater bar into reverse in short bursts to free.
Beware of the direction of rotation of the beater bar and conveyor.
A loaded machine running too long in reverse may be seriously damaged.
Never attempt to clear the product by hand or with a tool (fork, etc.) while the
machine is running.
Never climb on the machine or work inside the body while the machine is
running.
Beware! Blades, conveyors and other parts in contact with the product may
wear out quickly.
Any part which, through wear, is in danger of coming away and getting mixed
up with the feed must be replaced immediately.