Krone Comprima F 125 XC-1, Руководство по эксплуатации

Страница: 319 / 374

Terminal error messages 8
Faults of the electrics/electronics 8.1
Comprima F 125 - 1, Comprima F 125 XC - 1, Comprima F 155 - 1, Comprima F 155 XC - 1, Comprima V 150 - 1,
Comprima V 150 XC - 1, Comprima V 180 - 1, Comprima V 180 XC - 1, Comprima V 210 XC - 1
Comfort 1.0_en
75
Possible cause Remedy
FMI 7: The blade cassette has not been raised and the universal shaft is active.
The blade cassette has not
been swung in. „
Swing in the blade cassette using the tractor hydraulics.
Sensor B08 “Blade cassette
up” is defective or has been
set incorrectly. „ Check and adjust sensor B08 “Blade cassette up”, refer to
page 52 .
522020-
Net wrapping
Possible cause Remedy
FMI 7: The net has not been pulled.
The net does not move during
the starting process. „
Only use net rolls with the prescribed dimensions.
The net roll is not correctly in-
serted in the reception device
and/or the roll braking device
is not set correctly. „ Insert the net roll according to the description, see chapter
Operation, “Inserting a net roll” and set the roll brake at the
same time.
„ In particular, check the net overhang. Make sure it is at least
250 mm.
The wrapping material brake
does not release correctly. „ Set the wrapping material brake, see chapter Settings,
“Setting the wrapping material brake”.
„
Check the axial clearance of the wrapping material brake.
The net is pulled earlier even
though the feed rocker arm is
not yet in feed position. „
Check sensor B02 “Tying process active”.
„
Check sensor B61 “Tying 1 (passive)” and set the feed
position,
refer to page 57 .
522020-
Chamber film wrapping
Possible cause Remedy
FMI 7: The film is not pulled.
The film does not move during
the starting process.
„
Only use film rolls with the prescribed dimensions.
The film roll is not correctly in-
serted in the reception device
and/or the brake discs are not
set correctly. „
Insert the film roll according to the description, see chapter
Chamber film wrapping, "Inserting the film".
„ Check and set the braking effect of the brake discs, see
chapter Maintenance, “Checking and setting the braking
effect of the brake discs”.
The film overhang is too short. „ Check the film overhang. Make sure it is at least 250 mm.
The tying actuator is defect-
ive. „ Check the tying actuator.
522021-
Net wrapping