Krone Comprima F 125 XC-1, Руководство по эксплуатации

Страница: 312 / 374

8 Terminal error messages
8.1 Faults of the electrics/electronics
68
Comprima F 125 - 1, Comprima F 125 XC - 1, Comprima F 155 - 1, Comprima F 155 XC - 1, Comprima V 150 - 1,
Comprima V 150 XC - 1, Comprima V 180 - 1, Comprima V 180 XC - 1, Comprima V 210 XC - 1
Comfort 1.0_en
Possible cause Remedy
FMI 4: There is a cable break/short circuit, general error or undervoltage.
The cabling is faulty. „
Check the cabling for damage, refer to page 64 .
One or several sensors/actu-
ators connected to the voltage
group are defective. „ An overview of the position of the sensors, actuators and
control units is provided in the circuit diagram, see appendix
“Circuit diagram”.
„
Check the sensor and cabling for damage, refer to page 64 .
The control unit KMC is de-
fective.
„
Replace the control unit KMC.
521102-
High
Voltage group (UB3) of the KRONE Machine Controller (KMC)
Possible cause Remedy
FMI 5: There is a cable break, general error or overload.
The cabling is faulty.
„
Check the cabling for damage, refer to page 64 .
One or several sensors/actu-
ators connected to the voltage
group are defective. „
An overview of the position of the sensors, actuators and
control units is provided in the circuit diagram, see appendix
“Circuit diagram”.
„
Check the sensor and cabling for damage, refer to page 64 .
The control unit KMC is de-
fective. „ Replace the control unit KMC.
521102-
Low
Voltage group (UB3) of the KRONE Machine Controller (KMC)
Possible cause Remedy
FMI 6: There is a short circuit or ground fault.
The cabling is faulty.
„
Check the cabling for damage, refer to page 64 .
One or several sensors/actu-
ators connected to the voltage
group are defective. „
An overview of the position of the sensors, actuators and
control units is provided in the circuit diagram, see appendix
“Circuit diagram”.
„ Check the sensor and cabling for damage, refer to page 64 .
The control unit KMC is de-
fective. „ Replace the control unit KMC.
521103-
High
Voltage group (UB4) of the KRONE Machine Controller (KMC)
Possible cause Remedy
FMI 3: There is a short circuit or an overvoltage.
The cabling is faulty.
„
Check the cabling for damage, refer to page 64 .
One or several sensors/actu-
ators connected to the voltage
group are defective. „ An overview of the position of the sensors, actuators and
control units is provided in the circuit diagram, see appendix
“Circuit diagram”.
„ Check the sensor and cabling for damage, refer to page 64 .
The control unit KMC is de-
fective.
„
Replace the control unit KMC.
521103-
Low
Voltage group (UB4) of the KRONE Machine Controller (KMC)