Malfunctions - Causes and Remedies
285
Pos: 38.26 /BA/Störungen - Ursachen und Behebung/Großpackenpressen/Störungen-Ursachen-Behebung Doppelknoter T4 @ 25\mod_1242033232885_78.doc @ 249228
No
.
Malfunction
Cause and/or remedy
3
First knot: (closing knot): Present only in the
upper twine strand.
3.1
Cause:
The twine bar has not caught the lower twine
strand.
Remedy:
Readjust the twine bar(refer to chapter "Setting the twine
bar (double knotter)”) Checking the needle setting (refer
to chapter settings “Needle setting”).
4
First knot: (closing knot) twine winds around
the knotter hook.
4.1
Cause:
The lower needle grasps to the left on the upper
twine.
Remedy:
Align the upper needle slightly to the left:
•
Release the knotter and turn the flywheel until the
upper needle lifts
•
Use a mounting lever (2) to align the upper needle
(1) to the left by about 1 - 2 mm
4.2
Cause:
Twine driver disc starts working too late.
Remedy:
Put the twine driver disc forward by turning clockwise
(see chapter Settings double knotter “Twine retainer”).
Please ensure that the knotter needle makes contact
to the knotter in the topmost position (refer to
chapter Settings “Upper dead point of the needles”
(double knotter))
5
First knot: (Schließknoten) Upper twine is
running through from one bale to the next.
Knot in the lower twine strand
5.1
Cause:
The lower needle grasps to the right on the upper
twine:
Remedy:
Align the upper needle slightly to the right:
•
Release the knotter and turn the flywheel until the
upper needle lifts
•
Use a mounting lever (2) to align the upper needle
(1) to the right by about 1 - 2 mm
Pos: 38.27 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
