Malfunctions - Causes and Remedies
280
Pos: 38.15 /BA/Störungen - Ursachen und Behebung/Großpackenpressen/Tabellarische Auflistung Einfachknoter T3 @ 24\mod_1241777135041_78.doc @ 248936
Malfunction
Cause and/or remedy
Twine
is tearing or shows signs of abrasion in
places:
1.
Right next to the knot.
1.
Rough twine guiding edges on the blade lever —
smooth the edges.
2.
At a distance of 40-50 mm from the knot.
2.
Rough twine guide edges.
3.
At a distance of 60-80 mm from the knot.
3.
Rough or worn knotter needle roll — smooth the
edges.
Smooth the rough rear side of the twine bar.
4.
At a distance of 800-1000 mm from the knot. 4.
Rough twine guide edges in the lower area of the
baling needle — smooth the edges.
Twine around an improperly tied bale is knotted
around the twine strand of the bale that
immediately preceded it.
1.
The twine has not been inserted in the twine
retainer because the distance between the needle
and twine driver is too great — correct the position
of the knotter needle.
2.
The twine driver and twine retainer do not form an
opening for receiving the twine — correct the
position of the twine driver and replace the worn
driver.
Twine is tearing inside the knot.
1.
Too big a gap between the scraper comb on the
blade lever and the back of the knotter hook —
align the blade lever with a light tap of the hammer.
2.
Too much tension on the twine retainer — reduce
tension on springs by loosening the hexagonal head
screw.
3.
Too much force of pressure.
Pos: 38.16 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
