KRONE ISOBUS-Terminal CCI 100
102
Pos: 24.43 /BA/Info-Center/Großpackenpresse/Beschreibung Pressvorgang/Presskanal leer @ 18\mod_1237458084755_78.doc @ 210552
7.7
Description of baling process
7.8
Bale channel chamber empty
When the control unit is switched on, the display remains in Manual Mode.
Note
The bale channel chamber must first be filled to a pressure of about 50 bar / 725 PSI for straw
and 25 bar / 362,5 PSI for silage there to prevent the bale channel flaps from bending out of
shape. When the bale channel is filled, the pressure must be set high enough so that the bale
will be as solid as desired.
To always achieve the same solidity of bales with materials of different properties (for example
with differing moisture content of materials on the same field), you should then switch into
automatic mode.
The program will then use the bale solidity that was previously reached from manual mode. The
contact pressure of the bale channel flaps in the bale channel chamber is controlled
independently by the job computer so that the preselected pressing force is achieved.
As the material becomes moister, it becomes more difficult to compress the bales. Because of
this, the bale channel flap pressure is reduced somewhat. As the material becomes drier, the
bale channel flap pressure increases again. The pressure display may deviate significantly in
the display. Bale quality and bale firmness stay constant.
For information:
The pressing force is recorded by two sensors on the inside of the front frame section. Then it is
amplified and sent to the job computer.
The job computer evaluates the signals and then controls the pressure of the hydraulic cylinders
of the bale channel flaps. The signals are also used on the control unit for the direction of
motion display. The greater the difference between the measured forces of the left and right
sensor, the stronger the indications for the direction of motion. If the indications for the direction
of motion are too strong or too weak, they can still be adjusted (see chapter menu 1-3
“Sensitivity of direction display”).
Pos: 24.44 /BA/Info-Center/Großpackenpresse/Beschreibung Pressvorgang/Presskanal voll @ 18\mod_1237458574396_78.doc @ 210576
7.8.1
Bale channel chamber full
Just like the chapter “Bale channel chamber empty” with the following differences:
1.
If you will be baling in automatic mode, you can switch into automatic mode immediately
after the machine starts. The last target force to be used will be used again in this case,
i.e. you can continue baling with the same settings after turning the machine off and back
on.
Note
The baling pressure setting should not have been adjusted after the control system is turned on
in manual mode, because the control system then "forgets" the last settings.
2.
If you will be baling in manual mode, the baling pressure should be adjusted to the
desired value immediately after the control system is started.
Pos: 24.45 /BA/-----Seitenumbruch------ @ 0\mod_1196175311226_0.doc @ 4165
