Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 116 / 134

12 Disturbance, cause and remedy
12.3 Disturbances at the twine tying unit
116
Bellima F 130
Original Operating Instructions 150000148_06_en
Disturbance: The net does not extend to the outer edges of the tied round bale.
Possible cause Remedy
The net is not decelerated
correctly during the tying
cycle. „ Set the wrapping material brake, refer to page 84 .
The net got caught in the cut-
ting unit. „ Set the cutting unit, refer to page 103 .
The starter rollers of the tying
unit are bent.
„
Check the tying unit; if necessary, have it replaced by a
KRONE service partner.
Disturbance: Directly after cutting, the net pulls out forwards between the starter rollers.
Possible cause Remedy
During the tying cycle, the
PTO speed is kept too low.
„
Carry out tying with a PTO speed of approx. 400 rpm.
Disturbance: During baling, the net pulls out between the starter rollers.
Possible cause Remedy
The tension springs at the cut-
ting unit have extended or are
torn off.
„
Change the attachment of the tension springs at the cutting
unit, or replace them.
12.3 Disturbances at the twine tying unit
For the "Twine tying" or "Net and twine tying" version
Disturbance: The twine is not injected when tying starts.
Possible cause Remedy
For version with "Mechan-
ical tie starting device":
The
operating cable is too long.
„
Check the setting of the operating cable, refer to page 55 .
Do not press the friction wheel
and the drive wheel together.
„
Check the setting of the friction wheel and the drive wheel,
refer to page 102 .
The pressure rolls on the tie
starting device are too slug-
gish.
„
Slightly loosen the screw on the pressure rolls and
retighten,
refer to page 120 .
„
Oil the bearing positions on the pressure rolls, refer to
page 120 .
The O-ring seal on the starting
device is defective.
„
Change the O-ring seal, as the friction wheel must not press
on the drive shaft without an O-ring seal,
refer to page 120 .
Disturbance: The twine slips off the edges of the round bale.
Possible cause Remedy
The twine limiters are not set
correctly. „
Position the twine limiter at the tying start unit further to the
inside,
refer to page 80 .
The crop is very dry and
crumbly. „
Position the twine limiter at the tying start unit further to the
inside,
refer to page 80 .
„ Slow down at the end of the baling process.
„
Before the start of tying, Have the round bale re-baled
without adding crops.
Disturbance: The twine is too far away from the edge of the round bale.