Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 106 / 134

11 Maintenance
11.13 Checking and setting the transverse worm conveyors of the pick-up
106
Bellima F 130
Original Operating Instructions 150000148_06_en
11.13 Checking and setting the transverse worm conveyors of the pick-up
RP000-220
After repair or maintenance to the pick-up, it may be necessary to reset the 2 transverse worm
conveyors (1) on the right-hand and left-hand machine side. The lower edge (4) of the
transverse worm conveyor (1) must be parallel to the scrapers (2) of the pick-up. Additionally,
the packer tines (3) must project approximately
10 mm over the scrapers (2) in front.
ü The machine is shut down and safeguarded, refer to page 24 .
ü
The drive chain of the pick-up is dismounted.
ü
The chain is raised.
Make the following settings equally on the right-hand and left-hand transverse worm conveyor:
„
Turn the transverse worm conveyor (1) so that its lower edge (4) is parallel to the scrapers
(2) of the pick-up. In this position, the packer tines (3) must project approximately
10 mm
over the scrapers (2) in front.
„
Mount the drive chain of the pick-up in this position.
11.14 Set and oil the drive chains
WARNING
Risk of injury due to moving drive chains
When working on drive chains, there is a risk of injury due to entanglement of loose long hair
or loose clothing.
„
When working on the drive chains, wear protective equipment, refer to page 18 .
„ Before working on any drive chains, shut down and safeguard the machine, refer to
page 24 .
11.14.1 Drive chain of the pick-up
RPG000-028