Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 64 / 134

8 Operation
8.10 Holding-down clamp
64
Bellima F 130
Original Operating Instructions 150000148_06_en
Setting the bearing pressure of the holding-down clamp
The spring (4) sets the bearing pressure of the holding-down clamp on the swath.
Property of the crops Spring (4) Bearing pressure of the
holding-down clamp
Dry crops „ Attach the spring (4) to a
borehole (5) further to the
right. The bearing pressure is in-
creased.
Moist crops „ Attach the spring (4) to a
borehole (5) further to the
left. The bearing pressure is re-
duced.
ü The machine is shut down and safeguarded, refer to page 24 .
Make the following settings equally on the right-hand and left-hand side of the machine:
„
Attach the spring (4) in correspondence with the swath, as shown in the table.
8.10.2 Dismounting/mounting the lower holding-down clamp
In case of crop blockage, the lower holding-down clamp can be dismounted temporarily. The
holding-down clamp must be mounted under working conditions.
RP000-142
ü The machine is shut down and safeguarded, refer to page 24 .
Dismounting
„ Dismount the linch pin (2) on the right-hand and left-hand machine side.
„
Remove the holding-down clamp (1).
Mounting
„
Insert the holding-down clamp (1) above the pick-up and secure it on the right-hand and left-
hand machine side using the linch pins (2).