Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 82 / 134

10 Settings
10.7 Adjusting the sensors of the electronic baling pressure indicator
82
Bellima F 130
Original Operating Instructions 150000148_06_en
10.7 Adjusting the sensors of the electronic baling pressure indicator
RP000-224
The sensors (3) of the electronic baling pressure indicator are located on the right-hand and left-
hand machine sides behind the side hoods.
Make the following settings equally on the right-hand and left-hand side of the machine:
ü
The machine is shut down and safeguarded, refer to page 24 .
ü The side hood is open.
Setting the sensor distance.
„ To check the dimension X between sensor (3) and control plate (4), set the black
preselection indicator (1) to the height of the red baling pressure indicator (2).
ð
The upper edge of the control plate (4) is located in the middle of the sensor (3).
„ Check dimension X.
ð
If the dimension is X=3 mm , the setting is correct.
ð
If the dimension is not X=3 mm , the sensor (3) must be set.
„ Loosen or tighten the screw connections of the sensor (3) until the dimension X=3 mm is
set.
Setting the control plate
If the indicator lamps of the electronic baling pressure indicator light up too soon or too late, the
control plate (4) must be set.
„
Loosen the screw connections (5) and change the position of the control plate (4) in the
oblong holes.
„
Switch the vehicle electrical system on.
„
Manually, move the red baling pressure indicator (2) to the black preselection indicator (1);
check whether the indicator lamps light up at the point in time when the two hands overlap.