12
Disturbance, cause and remedy
12.10 Setting the mechanical baling pressure indicator
122
Bellima F 130
Original Operating Instructions 150000148_06_en
Make the following settings equally on the right-hand and left-hand side of the machine:
Dismount the rear side guard (1).
Check the dimension X between the roll pin (2) and the lock hook (3).
ð
If the dimension is
X=5-7 mm
, the setting is correct.
ð
If the dimension is not
X=5-7 mm
, the tailgate lock must be set.
To set the tailgate lock, loosen the counter nut (4) and turn the piston rod (5) until the
dimension
X=5-7 mm
.
12.10
Setting the mechanical baling pressure indicator
With the bale chamber empty and the tailgate closed, the baling pressure
indicator is not in position "0"
RPG000-050
If the baling pressure indicators (4) and (5) do not exactly overlap, or if the red baling pressure
indicator (5) is not in position "0", the baling pressure indicators must be readjusted. This setting
must be checked and adjusted equally on the right and left side of the machine.
ü
The tailgate is closed.
ü
The respective side guard on the right-hand or left-hand machine side is open.
Insert a mounting lever (1) into the gap between tailgate and chassis.
Push the tailgate to the rear until the lock hook (3) rests against the roll pin (2).
RPG000-043
The pictured tensioning device is located on the left-hand as well as on the right-hand machine
side, depending on the baling pressure indicator to be aligned.
