Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 99 / 134

Maintenance 11
Bleed the friction clutch on the universal shaft 11.7
Bellima F 130
Original Operating Instructions 150000148_06_en 99
Checking oil level
The oil level must reach up to the inspection hole (5).
If the oil does not reach up to the inspection hole (5):
„ Unscrew the locking screw of the inspection hole (5).
„
Fill in new oil through the inspection hole (5) up to the overrun. Make sure that the oil
complies with the applicable specification,
refer to page 39 .
„ Mount the locking screw of the inspection hole (5) tightening torque, refer to page 96 .
Changing oil
ü A suitable container is available for escaping oil.
„
Unscrew the locking screw of the inspection hole (5).
„
Unscrew the drain plug (4) and drain the oil.
„
Mount the drain plug (4), tightening torque refer to page 96 .
„
Fill in new oil through the inspection hole (5) up to the overrun. Make sure that the oil
complies with the applicable specification,
refer to page 39 .
„
Mount the locking screw of the inspection hole (5) tightening torque, refer to page 96 .
11.7 Bleed the friction clutch on the universal shaft
RPG000-053
After longer downtimes, the deposits from the friction clutch can stick to the friction surfaces.
Vent the friction clutch before use:
„
Loosen the 8 screws (1) crosswise to take the spring pressure off the outside washers (2).
„ Turn the universal shaft manually.
„
Tighten the 8 screws (1) crosswise until the cover ring (3) is positioned directly on the
outside washers (2). Ensure that the screws (1) are not overtightened.
„ Undo the 8 screws (1) by one sixth of a turn.