Krone Bellima F 130, Оригинальная инструкция по эксплуатации

Страница: 84 / 134

10 Settings
10.10 Setting the wrapping material brake
84
Bellima F 130
Original Operating Instructions 150000148_06_en
For the driver (1), the dimension must be X=38 mm , and for driver (2) the dimension must be
Y=20 mm .
„
To set the driver (1), loosen the screws (3) and move the driver (1) until the dimension X=38
mm .
„ Tighten the screws (3).
„
To set the driver (2), loosen the screws (4) and move the driver (2) until the dimension Y=20
mm .
„ Tighten the screws (4).
10.10 Setting the wrapping material brake
For the "Net wrapping" or "Net and twine tying" version
If the net is not cut off correctly, check and set the wrapping material brake.
ü
The storage compartment is open and the roll holder is swung forward.
ü
The machine is shut down and safeguarded, refer to page 24 .
Setting the spring tension
RPG000-051
The no-load brake spring (3) must be set so that the net can be properly retracted but is still
held taut.
The main brake spring (6) must be set so that it takes some effort to rotate the net roll manually,
and that the net is cut off properly.
„
To set the no-load brake spring (3), loosen the counter nut (2) and correct the setting at the
setting screw (1).
„
To set the main brake spring (6), loosen the counter nut (5) and correct the setting at the
setting screw (4).
„ After setting, re-tighten the counter nuts (2) and (5).