Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
79
Service and maintenance
Oil replacement in the driving shaft
The oil in both hubs and banjo cover must be replaced.
• Place the machine on level ground.
• Make a drain hose with a thread that fits in the drain hole (4),
see picture on the previous page.
• Fit the hose in the drain hole whilst it is in its upper most
position.
• Carefully run the machine forwards/backwards so that the drain
hole ends up in its bottom most position.
• Allow the oil to run out through the hose into a suitable
container.
• Repeat the procedure on the other side.
• Drain the banjo cover through the drain plug (5).
• As the engine oil has a high degree of viscosity, it is suitable to
drain the oil when hot or over night.
• Replace the three drain plugs (4 and 5).
• Place the machine so that the level markings on the hubs (1) are
horizontal.
• Fill the drive axle with oil through the three filling holes/level
holes (2 and 3).
• Replace the three drain plugs/level plugs (2 and 3).
• Inspect the breathing valve (6) and clean as necessary.
