Instruction manual SMV 10 600B – 60 1500B Publ. no. 6196.082 1117, Version 02
49
Service and maintenance
CLEANING
Clean the machine
The intervals between the cleanings depend on the type of work
performed by the machine. If it is used in extremely aggressive
environments where it is exposed to, for example, salt water,
fertiliser, chemicals, cement etc., it should be cleaned thoroughly
when the work is finished.
WARNING
Hot steam or aggressive degreasers should be
used with great care. Use protective clothing and
goggles.
• Protect all electrical components and the air cleaner intake so
that steam, water etc. does not penetrate during cleaning.
• Clean in particular the areas around the oil filling and the
lubrication points prior to service.
• If a degreasing agent is used when cleaning, ensure that the
agent has sufficient time to penetrate and then rinse with a hard
water jet.
• After cleaning the engine, it should be run warm to allow it to
dry and to ensure that penetrating water has not caused any
faults.
• All the materials used for cleaning should be taken care of in an
environmentally friendly way.
• Always lubricate after cleaning.
Change the cabin filter
The filter for the climate control is under the right panel.
• Loosen the screws (1).
• Remove the lid (2).
• Pull up the filter (3) carefully in order to avoid that dust enter
the climate control or the cabin.
• Replace the filter with a new one.
