Komatsu WA800-3E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 253 / 336

MAINTENANCE
SERVICE PROCEDURE
4-29
CHECK AXLE OIL LEVEL, ADD OIL 4
WARNING
The parts and oil are at high temperature immediately after the engine is stopped, and may cause burns.
Wait for the temperature to go down before starting the work.
Perform this procedure if there is any sign of oil on the axle
case.
Inspect the machine on a horizontal surface.
(If the road surface is at an angle, the oil level cannot be
checked correctly.)
1. Stop the machine in a horizontal place.
2. Stop the engine, then wait for the oil temperature to go
down.
3. Remove level plug (1).
4. Check that the oil level is near the bottom of the plug hole.
5. If the oil is not near the bottom edge of the hole, add oil
through oil filler (F).
6. If the oil level is correct, install level plug (1)
Tightening torque: 127 to 177 Nm (13.0 to 18.0 kgm)
CLEAN AXLE CASE BREATHER 4
1. Stop the machine in a horizontal place.
2. Stop the engine.
3. Use a brush to clean off any mud or dirt from around the
breather.
4. After removing all the mud or dirt from around the breather,
remove the breather, and soak it in flushing liquid to clean
it.
When cleaning the breather, clean the breathers at two
places (front and rear).
After removing the breather, take steps to prevent dirt or
dust from entering the mount.
5. Install the breather.
When cleaning the breather, clean the breathers at two
places (front and rear).