Komatsu WA800-3E0, Руководство по эксплуатации и техническому обслуживанию

Страница: 205 / 336

OPERATION
LONG-TERM STORAGE
3-143
LONG-TERM STORAGE 3
BEFORE STORAGE 3
When keeping in long-term storage (more than one month), store as follows.
q
Clean and wash all parts, then store the machine indoors. If the machine has to be stored outdoors, select
level ground and cover the machine with a sheet.
q
Completely fill the fuel tank. This prevents moisture from collecting.
q
Lubricate and change the oil before storage.
q
Coat the exposed portion of the hydraulic cylinder piston rod with grease.
q
Disconnect the negative terminals of the battery and cover it or remove it from the machine and store it sepa-
rately.
q
Lock each control lever with the lock lever.
q
To prevent corrosion, be sure to fill the cooling system with Supercoolant (AF-NAC) or permanent type anti-
freeze (density between 30% and 68%).
DURING STORAGE 3
WARNING
If it is necessary to perform the rust-prevention operation while the machine is indoors, open the doors
and windows to improve ventilation and prevent gas poisoning.
q
During storage, operate and move the machine for a short distance once a month so that a new film of oil will
coat moving parts. At the same time, also charge the battery.
q
When operating the work equipment, wipe off all the grease from the hydraulic cylinder rods.
q
If the machine is equipped with an air conditioner, operate the air conditioner for 3 to 5 minutes once a month
to lubricate all parts of the air conditioner compressor. Always run the engine at low idle when doing this. In
addition, check the refrigerant level twice a year.
AFTER STORAGE 3
NOTICE
If the machine has been stored without carrying out the monthly rust-prevention operation, consult your
Komatsu distributor before using it.
When using the machine after long-term storage, do as follows before using it.
q
Wipe off the grease from the hydraulic cylinder rods.
q
Add oil and grease at all lubrication points.
q
When the machine is stored for a long period, moisture in the air will mix with the oil. Check the oil before and
after starting the engine. If there is water in the oil, change all the oil.