Installing the PROCESSOR
981088 – September 1995
13
Installing the PROCESSOR Through the Wall
Note
• These instructions assume that you are setting the PROCESSOR on a Kodak M35, M43, and Clinic 1
MOUNTING STAND.
• The Kodak X-Omat M43 Through-the-Wall Kit, CAT No. 871-3109, is available and includes:
Planning the Site
[1] Check that the dimensions and location of the hole in the wall match the WALL OPENING in Figure 8 on
Page 14.
[2] Determine the other requirements of your site, such as the location of these items:
• FLOOR DRAIN
• REPLENISHMENT TANKS
– If the REPLENISHMENT TANKS are to be located outside the darkroom, decide whether you will
locate them inside the MOUNTING STAND or outside the MOUNTING STAND.
• main water supply VALVE
• main power supply CIRCUIT BREAKER, which should be located:
– outside of the darkroom
– within sight of the PROCESSOR and be accessible by the operators and service personnel
Qty
Item
1
FOAM BLOCK, LIGHT LOCK
2
FOAM GASKET, LIGHT LOCK
6
HOSE CLAMPS #12 for DRAINS
4
HOSE CLAMPS #2 for REPLENISHMENT HOSES
2
HOSE, Opaque,
3
⁄
8
in. ID, 3 ft., for REPLENISHMENT HOSES
3
HOSE, Opaque,
3
⁄
4
in. ID, 4 ft., for DRAINS
2
FITTING, Barbed,
3
⁄
8
in., for REPLENISHMENT HOSES
2
EYEBOLTS
2
NUTS for EYEBOLTS
3
FITTING, Barbed,
3
⁄
4
in., for DRAINS
2
WASHERS for LEVELING FEET
2
WASHERS for EYEBOLTS
