RC04-PCR-LA
Operation Check 3-1
Chapter 3
Operation Check
Describes the operation check that must be conducted prior to opera-
tion of the Remote Controller.
After connecting the Remote Controller by the steps described in Chap-
ter 2, check the Initial Setup Status and make an operation check.
Always make an operation check as described in this chapter, if you
have installed a new Remote Controller or changed its location, if the
operator changes, or if the Remote Controller has not been used for a
long time.
Before operating this device, read through the PCR-LA AC Power
Supply Operation Manual and gain an understanding of the basic
operations of the AC power supply.
3.1
Checking the Initial Setup Status
The condition in which a PCR-LA AC power supply and this device
are simultaneously purchased and power is fed for the
fi
rst time (fac-
tory shipment status) is called Initial Setup Status. The following
fi
g-
ure shows the remote controller LCD display under this condition.
The main setting in the Initial Setup Status are as follows:
• OUTPUT
OFF
• RANGE
100 V
• AC/DC
AC
• Frequency
50.00 Hz
• Voltage
0.0 V
• Voltage display mode
RMS
• Current display mode
RMS
If the Remote Controller is not in the Initial Setup Status, use the reset
function to activate the Initial Setup Status. Reset can be performed
either on the PCR-LA AC power supply or via the Remote Controller.
To perform a reset on the PCR-LA AC power supply, see instructions
5 0 . 0 0 H z
0 . 0 0 A
0 . 2 V
F R Q
I r m s
V r m s
Содержание RC04-PCR-LA
Страница 1: ...RC04 PCR LA Part No Z1 002 902 IA002963 Jan 2007 OPERATION MANUAL REMOTE CONTROLLER PCR LA Series...
Страница 10: ...1 4 General RC04 PCR LA...
Страница 78: ...7 4 Specifications RC04 PCR LA 7 2 Dimensions Fig 7 1 Dimension of RC04 PCR LA 40 MAX 55 128 180 Unit mm...
Страница 100: ...A 22 Appendix RC04 PCR LA...
