60
3. Montage / Raccordement électrique
3.2 Montage des sondes
La sonde peut être fixée par collage ou à l'ai-
de de chevilles sur les emplacements sou-
haités.
Collage
(Fig. 1) Poser le ruban adhésif double-
face (5) sur la face lisse de la plaque (6). Re-
lier la plaque et le support (7) à l'aide de la
vis (8). Presser le support global sur le fond
propre et enclipser la sonde (11).
Chevillage
(Fig. 1) Enfoncer la cheville (10) dans l'alésage
souhaité (Ø 5 mm). La plaque (6) et le support
(7) doivent être vissés à l'aide de la vis (9), et la
sonde (11) enfoncée sur le support.
Remarque concernant le boîtier d'alarme
n° 20221 :
(Fig. 1) La sonde optique est fixée horizon-
talement sur le support. Le retrait des œillets
permet de fixer la sonde au niveau le plus
bas.
3.3 Transmetteur de signaux extérieur
Le transmetteur de signaux extérieur (réf.
20162) destiné à transmettre le signal d'alar-
me dans d'autres zones peut être connectée
le cas échéant.
3.4 Contact sans potentiel
En option, une platine supplémentaire avec
un contact sans potentiel (réf. 80072) peut
être connectée, par ex. pour un raccorde-
ment au tableau de commande au niveau de
la gestion technique centralisée. Enficher la
carte supplémentaire au moyen des quatre
séparateurs sur la carte de base (Fig. 2).
Puis placer au-dessus le raccord de la plati-
ne sur la carte de base (Fig. 3 + 4).
3.5 Raccourcissement des circuits de com-
mande
Les circuits de commande peuvent être éga-
lement raccourcis le cas échéant. Nous vous
recommandons de n'étamer que les pointes
sur les extrémités du fil. Lors de l'utilisation
de raccords, il faut veiller à ce que les bornes
de connexion soient conçues pour une sec-
tion transversale maximale de 2,5 mm².
Cette section transversale ne doit pas être
dépassée.
④
②
③
①