7
3. Montage / Elektroanschluss
3.6 Installation / Kabelanschluss
Die Anschlussleitungen sind gemäß An-
schlussplan anzuschlie ssen. Dazu zunächst
in den Kabelverschrau bun gen die Dichtung
mit ei nem Schraubenzieher durchstoßen (Bild
a), die Leitung einführen (Bild b) und anklem-
men (Bild c). An schlie ßend kann die Mutter
der Kabelverschraubung mit der Hand fest-
gezogen werden (Bild d).
Beim Anschluss des potentialfreien Kontakts
sind die technischen Daten zu beachten.
Die Dichtungen der Kabelverschraubungen,
die nicht verwendet werden, d.h. durch die
keine Leitung angeschlossen wer den, dürfen
nicht durchstoßen werden. Sie dienen zur Ab-
dichtung des Ge häu ses.
WICHTIG:
Alle an dem elektrischen Schaltgerät ange-
schlossenen Kabel sind bei beendeter In -
stallation durch geeignete Maßnahmen (z.B.
Kabelbinder) so zu fixieren, daß sie im 1-Feh-
ler-Fall, also beim Lösen ei ner Verbindung,
nicht zu einer Gefährdung führen.
Die Sondenleitung ist getrennt von den Netz- und Motorleitungen zu verlegen, um Stör -
einflüsse zu vermeiden.