R AD AR
46
When operating this step, be sure to confirm that the light is on
(4)
Please Perform operation under the HANDLE mode
( Before moving crossrail, be sure to confirm the safety of personnel and
machinery, then perform moving)
Press the to up or down the crossrail,when the crossrail manually
moved to the desired position (positioning pin higher than
positioning seat about 1cm), then press the key, so that the left then
positioning pin will be reset
next press the key, so that the right positioning pin will be reset
(need to check it by visual).
After confirm that the left & right side location pins positioned, start to press
button until the will light up.
(5) As crossrail perform initial setting, should check the micro switch signal on left
side of crossrail is normal or not and press the micro switch down by hand touch
from lower of No.1 to upper of No.5, when press down each number of switch,
should check the display number of crossrail position on display is correct or not.
Regarding the Keep relay setting, please refer to the relevant manual.
(1)
(2)
(3)
(4)
If encounter some situations under when processing program under AUTO mode,
Please use tool retraction function. Operation orders are as below.
Press “FEED HOLD” button.
Choose MANUAL MODEL, and then press key until the light on.
Press “SP STOP KEY” until the light on. The spindle will stop turning.
Make “OVERRIDE” in 0% position. Move the axis to a safe position.
Restart the program, choose the auto model. Press “CYCLE START KEY” to turn
4.4 Tool retraction function
(suitable O.D. processing)
the spindle. Program will automatically move to retract position.
(5) Adjust “OVERRIDE”, the program will process automatically.
L2
L1
Z
Z
L- FOR
R- FOR
Z
MANUAL
MODEL
Note:
(need to check it by visual),
4.
Operating
4.
Operating
4.
Operating
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
