R AD AR
36
4.2.6
Single block key: As this switch is "ON" in auto-run, can execute single block
(1)
operating, need to press the cycle start(CYCLE START) key to execute the
The stop key of power tool: As this function key is "ON", the power tool
(2)
ratio of MDI program controlled by JOG speed rate. The rapid moving G00
Program restart key: It’s active on automatic model. As this key is "ON", the
(3)
programs need to pause a running program temporarily, and restarts from the
Select stop key: As the key is "ON", the M01 is active to be program executed
(4)
which will temporarily stop the machine to perform( The main spindle should
Delete single block key: As the key is "ON", the single block with "/" mark will
not be executed. If this key is on OFF, the single block with "/" mark will be
(5)
CF-axis start (C ON): It is active in the ZRN mode,
AS the key(C ON) is "ON", can move the .C-axis by hand wheel
(6)
or (+ C) and (-C) keys on panel.
This light will light on when M30 is executed.
(7)
stop or not, can set by K parameters. Please refer to K parameters). The
Panel function switch
next block.
changes to JOG speed. (set by parameter)
(Setting by parameter, the parameters refer to instructions)
pause position to begin the machining program. (Refer to 4.4 PRS operating
steps)
function is same as M00, should press the cycle start key to continue execution.
When the switch is "ON", the light is on.
executed.
PRS
DRN
SBK
BDT
M01
ON
C
ON
C
SBK
DRN
PRS
M01
BDT
ON
C
Figure 4.13
Figure 4.14
Live spindles are low gear when using M51.
Live spindles are high gear when using M52.
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
4.
Operating
Property
of
Kent
Industrial
USA
Do
Not
Reproduce
