Series 3700 System Switch/Multimeter Reference Manual
Section 3
:
Using the Front Panel
Document Number: 3700S-901-01 Rev. A / August 2007
3-5
The bottom line of the display (4) contains the attribute symbols. The symbols that appear are
dependent on whether the attribute exists for the selected function. If the symbol has also
contains a value, the third column in the table indicates the value definition. The following table
indicates the DMM attribute symbols that may appear on the front panel.
Front panel DMM attribute
Symbol
Values
range
R=
AUTO or n, here n equals the range
nplc
N=
n, where n equals the nplc
auto delay
AD
+ for ON, 1 for ONCE, or 0 for OFF
auto zero
AZ
+ for ON or
– for OFF
line sync
LS
+ for ON or
– for OFF
limit
LIM
+ for a limit enabled or
– for limits disabled
detector bandwidth
DBW
3, 30, or 300
threshold
THR=
n, where n indicates the threshold
aperture
A=
n, where n indicates the aperture setting
dry circuit
DRY
+ for ON or
– for OFF
offset compensation
OC
+ for ON or
– for OFF
thermocouple sensor K
K_T/C
N/A
thermocouple sensor T
T_T/C
N/A
thermocouple sensor E
E_T/C
N/A
thermocouple sensor R
R_T/C
N/A
thermocouple sensor S
S_T/C
N/A
thermocouple sensor B
B_T/C
N/A
thermocouple sensor N
N_T/C
N/A
thermistor
THRM
N/A
three-wire RTD
3RTD
N/A
four-wire RTD
4RTD
N/A
simulated reference junction
RJ_SIM
N/A
internal reference junction
RJ_INT
N/A
external reference junction
RJ_EXT
N/A
NOTE
To access the main menu, press the
MENU
key.