Intellipuff Service Manual
Page 24 of 51
Issue D 27/02/2014
EP59-12317
Exiting Calibration
In most of the forms described so far, there is a Restart button which reverses
the calibration process to a certain previous point in the program where
appropriate. In most cases the Restart button unloads the current form and
ends all the programming behind it and loads the mode selection form, from
which the EXIT button can be pressed to abandon calibration. Exiting the
calibration process in this way allows the host PC to release the occupied
RS232 port resources properly so that they are available for the next time the
calibration process or any other program that needs access to these
resources is run. In this case the form below is displayed and EXIT button can
be pressed to end the Process. At the end of calibration and after pressing the
EXIT button, the Pulsair will switch itself off in few seconds or the user can
also switch it off to reset the unit before use.
