Full Digital Color Doppler Ultrasonic Diagnostic Instruments (Vet) User’s Manual V1.01
- 32 -
Rotate
Select
knob to highlight the [Image Enhance] menu item, press
Select
knob item to confirmation
select [Image Enhance] item, and then rotate
Select
knob to adjust it.
8.1.2.17 Adjusting the Acoustic Power
Acoustic power is adjusted to increase or decrease the transmitting frequency of the probe.
Steps:
Move cursor to [A. Power] menu item and press
Set
key to adjust it.
Rotate
Select
knob to highlight the [A. Power] menu item, press
Select
knob item to confirmation select
[A. Power] item, and then rotate
Select
knob to adjust it.
8.1.2.18 Adjusting the Vertical Reverse
Vertical reverse is used to adjust two-dimensional image flip up/down.
Steps:
Move cursor to [Vertical Reverse] menu item and press
Set
key to adjust it.
Rotate
Select
knob to highlight the [Vertical Reverse] menu item, press
Select
knob item to
confirmation select [Vertical Reverse] item, and then rotate
Select
knob to adjust it.
8.1.2.19 Adjusting the Horizontal Reverse
Horizontal reverse is used to adjust two-dimensional image flip left/right.
Steps:
Move cursor to [Horizontal Reverse] menu item and press
Set
key to adjust it.
Rotate
Select
knob to highlight the [Horizontal Reverse] menu item, press
Select
knob item to
confirmation select [Horizontal Reverse] item, and then rotate
Select
knob to adjust it.
8.1.2.20 Adjusting the Body Type
Set the appropriate image parameters by adjusting the body type.
Steps:
Move cursor to [Body Type] menu item and press
Set
key to adjust it.
Rotate
Select
knob to highlight the [Body Type] menu item, press
Select
knob item to confirmation
select [Body Type] item, and then rotate
Select
knob to adjust it.
8.2 Color Doppler Flow Imaging (Color) Mode
Color is a color flow imaging technology which adds the color-coded qualitative information
concerning the relative velocity and direction of fluid motion in the B-Mode image.
8.2.1 Entering the Color Mode
Steps for entering the Color mode are as follows:
1.
Select the appropriate probe and exam type, and optimize the B mode image.
2.
Press the
Color
key on the control panel to enter the color mode, as shown in Figure 8-2.
