Juniper JUNOSE, Руководство по настройке

Страница: 695 / 738

4.
Activate the neighbors with which routes of the L2VPN address family are
exchanged for this PE-to-PE BGP session. Use the
bgp dampening command
and BGP neighbor commands to configure additional address family parameters
for the session. No other commands are supported in this address family.
host1(config-router-af)# neighbor 10.2.2.2 activate
host1(config-router-af)# neighbor 10.2.2.2 next-hop-self
5.
Exit the address family.
host1(config-router-af)# exit-address-family
6.
Create the VPWS address family to configure the router to exchange layer 2 NLRI
for each VPWS instance configured on the router.
You must issue the address-family vpws command separately for each VPWS
instance configured on the router.
host1(config-router)# address-family vpws l2vpnA
host1(config-router)# address-family vpws l2vpnB
Related Topics
■
Configuring BGP Routing on page 3
■
Configuring BGP-MPLS Applications on page 373
■
address-family l2vpn
■
address-family vpws
■
exit-address-family
■
neighbor activate
■
neighbor next-hop-self
■
neighbor remote-as
■
neighbor update-source
■
router bgp
Configuring MPLS LSPs for VPWS
As part of a VPWS L2VPN configuration, you must create MPLS label-switched paths
(LSPs) to connect the local PE router and the remote PE router.
This section explains one way to create a basic MPLS configuration using the mpls
and mpls ldp commands.
To configure MPLS LSPs on the PE router:
1.
Enable MPLS on the virtual router.
host1(config)# mpls
Configuring MPLS LSPs for VPWS
■ 659
Chapter 13: Configuring VPWS