Jungheinrich ECE 118, Руководство по эксплуатации

Страница: 41 / 81

0406
.GB
E 14
5.4 Parameter settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (
o
)). If in doubt, cancel the setting by pressing the
o
key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code lock parameters
Setting procedure for trucks without a display instrument (CANDIS (
o
)):
– Enter the three-digit parameter number and confirm with Set key (17).
– Enter a value according to the parameter list, or change it and confirm with
the Set key (17).
Z
If the entry is incorrect, the LED (16) on the
o
key (21) flashes red. If you enter
the parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To complete the setting, press
the
o
key (21).
Display instrument
(CANDIS)
LED (16)
o
key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours are
displayed
284
.
0
Green
flashing
Off Off Off
0406
.GB
E 14
5.4 Parameter settings
To change the truck setting you must enter the master code.
Z
The factory setting for the master code is 7-2-9-5.
M
When starting the truck for the first time, change the master code (see Section 5.1).
F
Safety instructions for trucks with a display instrument (CANDIS (
o
))
– Parameter settings must be made carefully and only by special trained personnel.
If in doubt, consult the manufacturer's service department.
– Each setting must be monitored on the LC display of the display instrument
(CANDIS (
o
)). If in doubt, cancel the setting by pressing the
o
key (21).
– Since changing any parameter will affect the truck's travel pattern, you must carry
out a test run in a specially designated work area.
To enter the master code:
– Press the
o
key
– Enter master code
Code lock parameters
Setting procedure for trucks without a display instrument (CANDIS (
o
)):
– Enter the three-digit parameter number and confirm with Set key (17).
– Enter a value according to the parameter list, or change it and confirm with
the Set key (17).
Z
If the entry is incorrect, the LED (16) on the
o
key (21) flashes red. If you enter
the parameter number again the setting can be entered or changed.
To enter more parameters, repeat the procedure. To complete the setting, press
the
o
key (21).
Display instrument
(CANDIS)
LED (16)
o
key
LED (18)
Key 1
LED (19)
Key 2
LED (20)
Key 3
Service hours are
displayed
284
.
0
Green
flashing
Off Off Off