Jung LB management, Руководство пользователя

Страница: 179 / 196

OPERATION 179
YOU WOULD LIKE TO... IMPLEMENTATION FURTHER INFORMATION
... increase the setpoint
temperature. − Tap the Plus button for less than one
second.
The setpoint temperature is increased by 0.5 °C
for each tap of the button. In cooling operation,
you cannot increase the setpoint temperature
using the Plus button.
... reduce the setpoint
temperature. − Tap the Minus button for less than one
second.
The setpoint temperature is reduced by 0.5 °C for
each tap of the button. In cooling operation, you
cannot increase the setpoint temperature using
the Minus button.
... call up the comfort
temperature. − Tap and hold the Plus button for longer
than one second.
... call up the ECO temperature. − Tap and hold the Minus button for longer
than one second.
... activate / deactivate the
automatic mode. − Press the Automatic button. Automatic operation cannot be activated if no
temperatures are saved.
... reset the temperature to
factory settings. − Press and hold the Reset button and the
AUTO button simultaneously for longer
than ten seconds.
A countdown starts in the display.
... display the time continuously. − Tap and hold OK and Reset buttons
simultaneously for ten seconds.
Pressing again switches off the display two
minutes after the buttons were pressed.
... activate / deactivate the lock
function. − Tap the Menu button and then OK.
− Tap the Plus or Minus button until “YES”
is shown on the display.
− Tap the OK button to confirm the
activation.
The display shows LOCK.
Alternatively, activate the lock function in the
menu with the Lock selection.
... deactivate the lock function. − Press the right arrow button briefly.
... change the time. − Tap the Menu button and select “Set”.
− Confirm the selection by tapping the OK
button and then make the settings.
− Confirm the new time by pressing the OK
button.
In the event of power failure, the time is
maintained for at least four hours.
... change the temperature
parameters. − Tap the Menu button and select TEMP.
− Confirm the selection by tapping the OK
button.
− Change the setpoint value by tapping
the Plus or Minus button.
− Confirm the new temperature by
tapping the OK button.
... activate or deactivate the
button lock. − Tap and hold the Minus and Auto
buttons for longer than one second.
LOCK is displayed or hidden.
... Change parameters for
control. − Tap and hold the Menu and Reset
buttons for longer than ten seconds.
A countdown from 9 to 0 is counted down on the
display.
... switch between setpoint and
actual temperature and the
time. − Tap and hold the OK button and the
AUTO button for longer than ten
seconds.
A countdown from 9 to 0 is counted down on the
display.
... switch on the display
permanently and switch it off
after 2 minutes. − Tap and hold the OK button and the
Reset button for longer than ten
seconds.
A countdown from 9 to 0 is counted down on the
display.
... restore the factory settings of
the device. − Tap and hold the Auto button and
the Reset button for longer than ten
seconds.
A countdown from 9 to 0 is counted down on the
display.