Jung LB management, Руководство пользователя

Страница: 149 / 196

6.3.9 Factory settings
The following settings are stored as factory settings on the standard display:
− Times for comfort and ECO temperature
MON – FRI SAT – SUN
COMFORT ECO COMFORT ECO
T1 06:00 08:30 07:00 22:00
T2 12:00 14:00
T3 17:00 22:00
− Automatic operation is active
− Automatic summer time changeover is active
− Controller output depends on the insert:
− Room thermostat insert = pulse width modulation
− Switch insert = two-point control
− Output of the actuator is normally closed ( NC )
− Heating optimisation is not active
− Temperature drop detection is not active
− Comfort temperature: 21 °C; ECO temperature: 18 °C; Frost protection temperature: 7 °C;
Cooling temperature: 24 °C
− Internal temperature sensor for the room temperature measurement is active
− Switch-off of the display after 2 minutes without pressing any button is active.
Press and hold the Reset button and the AUTO button simultaneously for 10 seconds to reset
the attachment to the factory settings. A countdown is then shown on the display. The reset is
performed when the countdown has run down to 0.
6.4 Activate functions
6.4.1 Activate automatic / manual operation
You can switch between automatic and manual operation by pressing the Auto button. If all
time switch blocks are deactivated, the attachment automatically switches to manual opera-
tion. Automatic operation can no longer be activated. During automatic operation, the display
shows AUTO. During manual operation, the display shows MANU.
TEMPERATURE CONTROL 149