Jung LB management, Руководство пользователя

Страница: 83 / 196

Note the following for the installation:
− Illuminated buttons must have a separate N terminal.
− Do not attach or replace the attachment under voltage, otherwise a malfunction can occur.
Proceed as follows to set the delay time:
1. Press and hold the TEST button for longer than four seconds.
After pressing the TEST button, the LED lights in the colour of the specified delay time.
2. Release the TEST button briefly and then press the button so often until it lights in the colour of
the desired delay time.
LED COLOUR SPECIFIED DELAY TIME
green Switch without delay time
ivory Delay time: 1 minute
Blue Delay time: 5 minutes
Yellow Delay time: 30 minutes
red Delay time: 60 minutes
The selected delay time is saved automatically after 30 seconds. The save process was success-
ful if the LED extinguishes.
ELECTRONIC SWITCH INSERT
Connecting and installing insert
L 1 N
L 1 L 1 N
16 A
N
AC 230 V
L
Master unit
2-wire satellite unit
Lighting
3-wire satellite unit Installation button
Note the following for the installation:
− If non-dimmable LED lamps are used, the neutral conductor must strictly be connected.
Operation without neutral conductor is possible if other lamps are used.
− Maximum 600 W LED or compact fluorescent lamps can be connected per 16 A circuit
breaker.
Setting operating mode
The operating mode must be appropriate for the load for any operation without neutral
conductor. The setting of the operating mode is usually performed automatically. However,
it can be necessary to set the operating mode manually.
The operating mode cannot be set for any operation with neutral conductor. In this case,
the LED indicator has no function.
LB MANAGEMENT LIGHT 83