Jetter JVM-407B-HMI, Руководство пользователя

Страница: 63 / 300

Jetter AG 63
JVM-407B Mounting and installation of the JVM-407B
Installing the HMI
Select a suitable place for the device to be mounted.
The place where the device is to be installed must meet the following
requirements:
 The installation surface must be level.

The installation surface should be no more than 5 mm thick.
 The installation location must allow air to circulate.

The installation location must be accessible for servicing.
 The installation location must be of sufficient size.
Do not install the device in locations that do not meet the a.m. requirements.
The following installation locations are unsuitable for mounting the HMI:
Unsuitable installation
location
Reason
Outdoor installation The HMI must not be exposed to rain or a jet of
water. Therefore, do not use a steam jet or other such
devices to clean the HMI.
Unventilated installation
location
The HMI could overheat as heat builds up.
Installation location close to
heat-sensitive materials
The materials could become warped or misshapen as
a result of heat produced by the HMI.
Uneven installation surfaces The installation surface could become misshapen
when fitting the HMI.
Fastening is unstable and precarious.
Consider ergonomic principles.
Select a user-friendly place for installation:
 The controls must be easy to reach.

The HMI screen must be easy to read.
Avoid installation locations that are unsuitable from an ergonomic point of
view:

Extreme angles, which could make it difficult to see the HMI
 Unsuitable lighting conditions with reflection and glare

Concealed installation locations that are difficult for the user to access
Selecting a place for
installation
Avoiding unsuitable
installation locations
Ergonomic principles