JCM ivizion ld, Эксплуатация и обслуживание

Страница: 63 / 158

P/N 960-100929R_Rev. 7 {EDP #148849} © 2017, JAPAN CASH MACHINE CO., LTD.
4 - 7
Disassembly/Reassembly iVIZION® Series Next-Generation Banknote Acceptor Unit Section 4
3. Carefully spread both sides of the PCB Support
apart (Figure 4-25 a
1
& a
2
) and slide the
Validation CPU Board (Figure 4-25 c ) and the
Controller CPU Board (Figure 4-25 d ) off of the
CPU Board Module.
4. Remove two (2) mounting Screws (Figure 4-25
b
1
& b
2
), and separate the Validation CPU Board
and the Controller CPU Board from one another.
USB FPC, Power FPC & Interface
FPC Cable Removals
To remove the USB FPC, the Power FPC and the
Interface FPC proceed as follows:
1. Remove the two (2) mounting Screws (Figure 4-
26 a
1
& a
2
) securing the Motor Unit to the Trans-
port Assembly, and remove the Motor Module
(Figure 4-26 b ) from the Transport Unit.
2. Remove the USB FPC (Figure 4-27 a ), the Power
FPC (Figure 4-27 b ) and the Interface FPC (Fig-
ure 4-27 c ) from the Transport Unit.
Figure 4-25 Validation CPU Board and Control
CPU Board Removal
Figure 4-25 Validation CPU Board and Control
CPU Board Removal
b
1
b
2
c
d
a
1
a
2
Figure 4-26 Motor Module Removal
Figure 4-26 Motor Module Removal
a
1
a
2
b
Figure 4-27 USB FPC, Power FPC & Interface
FPC Cable Removal
Figure 4-27 USB FPC, Power FPC & Interface
FPC Cable Removal
a
b
c
Dashed Line
for Fold Up
Solid Line
for Fold Down
NOTE: Carefully observe the Up and
Down Fold Line indications shown
by the two (2) Cyan Arrows in Figure
4-27. DO NOT bend them in an
opposite direction!
NOTE: When installing new FPCs,
fold-up along the Solid Lines and
fold-down along the Dashed Lines
before setting them in place. Once
an FPC is folded, DO NOT un-fold it
back again or fold in the opposite
direction.