P/N 960-100929R_Rev. 7 {EDP #148849}
© 2017, JAPAN CASH MACHINE CO., LTD.
4 - 6
Section 4
iVIZION® Series Next-Generation Banknote Acceptor Unit
Disassembly/Reassembly
5. Remove the two (2) mounting Screws (Figure 4-
a
1
&
a
2
) securing the Home Position Sensor
b
).
6. Remove the Home Position Sensor Board and the
Home Position Sensor FFC Assembly (Figure 4-
c
) from the Transport Unit.
7. Remove the three (3) mounting Screws (Figure 4-
d
1
,
d
2
&
d
3
) securing the Interface Connector
f
), and then remove
the three (3) Flat Ribbon Cables from the Inter-
face Connector Board (Figure 4-21
e
1
,
e
2
&
e
3
).
RFID Module & Harness Removals
To remove the RFID Module and RFID Harness
proceed as follows:
1. Remove the two (2) mounting Screws (Figure 4-
a
1
&
a
2
) securing the RFID Module to the back
side of the Transport Unit (Figure 4-22
b
).
2. Remove the RFID Module and the RFID Harness
c
) from the Transport Unit.
Validation CPU & Controller CPU
Board Removals
To remove the Validation CPU Board and the Con-
troller CPU Board from the CPU Board Module,
proceed as follows:
1. Remove the four (4) mounting Screws (Figure 4-
a
1
to
a
4
) that are securing the CPU Board Mod-
d
) to the Transport Unit, and
unplug the two (2) Signal Connectors (Figure 4-
23
b
1
&
b
2
) with the three (3) Flat Ribbon Cables
c
1
,
c
2
&
c
3
) located on the CPU
Board Module and remove the CPU Board Mod-
ule from the Transport Unit.
2. Remove the single (1) mounting Screw (Figure 4-
a
) and remove the Optional Extension Mem-
ory Board if installed (Figure 4-24
b
) from the
assembled Extension Memory Board.
Figure 4-21
Home Position Sensor FFC Assembly and
Interface Connector Board Removals
Figure 4-21
Home Position Sensor Board, Home
Position Sensor FFC Assembly and
Interface Connector Board Removals
a
2
a
1
b
c
d
3
d
2
d
1
e
1
e
2
e
3
f
Figure 4-22
Figure 4-22
RFID Module & Harness Removal
a
2
1
b
c
Figure 4-23
CPU Board Module Removal
a
1
a
3
a
4
b
1
b
2
c
1
d
c
2
c
3
Figure 4-24
Extension Memory Board Removal
b