3
Tractor operation
49
drawbars; or allowed to swing the full
width of the frame. The maximum lateral
swing is 240 mm (9.5 in) for normal duty,
194 mm (7.6 in) for heavy duty.
To change the position of the drawbar
(Fig. 29):
1. Remove the four ’R’ clips (1).
2. Remove the two limit pins (2).
3. Reposition the drawbar (3) and refit
the pins and ’R’ clips, or leave it free
to swing. Store the pins and ’R’ clips
in the tool box when not in use.
Fig. 29:
3
1
2
Position
Normal duty
Heavy duty
A
120 mm
-
B
240 mm
194 mm
Table 3-4
Fig. 30: Drawbar off-set when in the center
hole (Heavy duty is for ITM 475 & 485)
Allow the drawbar to swing when pull-
ing ground engaging equipment which does
not require accurate positioning. This will
make steering and turning easier.
Fix the position of the drawbar when
pulling equipment which requires accurate
positioning and transporting equipment.
Front mounted weight frame
(Fig. 31)
The front-mounted weight frame is
bolted to the front support casting.
A maximum of eight 34 kg (76 lb)
weights can be fitted. A towing hitch hole
and pin are provided in the centre of the
frame.
Fig. 31: Front mounted weights.
Attaching the weights:
1. Hook the top of the weight over the
weight frame with the base of the
weight tilted outwards. Lower the
weight and put them on the frame.
2. Before attaching the bolts, oil the
Содержание ITM 475
