Inovance SV660, Руководство для продвинутых пользователей

Страница: 278 / 426

-277-
7 Control Mode
Position
Position comparison value 2
Position comparison output
Time
Position comparison value 1
Actual position
Pulse output width
■
Only one pulse will be output when the stop position is the same with the position comparison
value, as shown in the following figure.
Actual position
Position
Position comparison
value
Position comparison
output
Time
Pulse output width
3) Interface of the software tool
For the convenience of setting the target position comparison value, the software tool provides the
function of division setting. Set a proper comparison mode, start point, and end point first.
■
In the single comparison mode, set the total running distance and number of comparison points.
After clicking " 等分设定 " (Division setting), the target value of the first point is updated to “Distance
x 1/Number of comparison points”, the target value of the second point is updated to “Distance x 2/
Number of comparison points”, and the target value of the Nth point is updated to “Distance x N/
Number of comparison points”.
■
In the cyclic comparison mode, " 距离长度 " (Distance length) is used to set the operating distance
between two adjacent point. " 比较点数 " (Comparison points) is used to set the numbers of points
to be compared cyclically. After clicking " 等分设定 " (Division setting), the target values of the 1st to
the Nth comparison points are updated to the values set in " 距离长度 " (Distance length).