Page 39
EN
Chapter 6 Installation
6 Installation
Observe the following notices when assembling and posi-
tioning the machine:
!
DANGER
In case of unqualified operation of the
small silo inoCOMB Cabrio, there is a danger to life
and health of the operating personnel as well as ma-
terial damage to the small silo or other assets.
!
DANGER
Rotating mixing, metering and pump
shafts. Danger of death due to being pulled into the
machine and crushed.
When the motors are running, the metering shaft ro-
tates in the material hopper, the mixing shaft in the
mixing tube and the pump shaft in the pump hopper.
• Do not reach into the rotating mixing or pump shaft.
• Do not bring any objects into the rotating mixing or
pump shaft.
1. Before working on the mixing or pump shaft, disconnect
the external power supply (main switch off). Only loosen
the screw of the protective grids when the machine is
switched off.
2. Pull out the mains plug.
3. Secure the machine against unexpectedly being switched
back on.
!
DANGER
Pressurised conveyor hoses.
Risk of injury and risk of property damage due to es-
caping and/or flying material, and/or bursting con-
veyor hoses.
• Before disconnecting the conveyor hoses, make sure that
the hoses are depressurised. To do so, check the pressure
indicator on the mortar pressure gauge. The pressure in-
dicator must display 0 bar!
• Before opening the hose coupling, let the small silo ino-
COMB Cabrio run in reverse to release any pressure! To
do this, press the “Reverse pump” pushbutton until the
pressure display on the mortar pressure gauge shows 0
bar.
Pushbutton “Reverse pump”
• Use only conveyor hoses which are permissible with an
operating pressure of 40 bar and a burst pressure of 120
bar, and are in a technically perfect condition (e.g. are
without any cracks or other external damage!).
Installation location requirements
• Ensure that there is enough space around the machine
to enable filling of the material hopper and machine op-
eration.
• Install the small silo inoCOMB Cabrio only on level, hor-
izontal ground.
• Prevent the machine from sliding.
• Cover the floor underneath the machine with a plastic
sheet, if it is not on a firm, tarmacked surface.
• Keep the machine in a dry, protected area in wet weather.
• Prevent direct exposure to sunlight, especially while in
continuous operation, in order to prevent the motor
from overheating.
• Do not use the machine at temperatures below 0° Cel-
sius to prevent the water-carrying parts from freezing.
For storage, dry out all water-carrying parts.
6.1 Delivery condition of the machine
The small silo inoCOMB Cabrio is delivered from the facto-
ry as a basic module. Before initial commissioning, assem-
ble the corresponding pump unit (with pump shaft, rotor,
stator and pressure gauge) and the mixing tube with the
mixing shaft.
NOTE
For the application of reprofiling mor-
tar, use an external site compressor.
