Page 55
EN
Chapter 12 Dismantling and disposal
12 Dismantling and disposal
After the machine’s period of use has expired, the machine
must be dismantled and sent for environmentally conscious
disposal.
12.1 Safety
• Only use trained or instructed personnel for dismantling
the small silo inoCOMB Cabrio.
• Only have work on the electrical control system carried
out by a qualified electrician.
WARNING
Risk of injury posed by improper disas-
sembly.
Stored residual energy, sharp components, points and
corners on and in the machine can cause injuries.
• Ensure there is enough space for disassembly.
• Wear gloves and safety boots to avoid injuries.
• Handle sharp-edged parts with care.
• Ensure that the workplace is tidy and clean. Loose com-
ponents and tools lying around or on top of each other
can cause accidents.
• Adopt good practice when dismantling the components.
• Note that some individual parts may be very heavy.
• Secure the individual parts to ensure these do not fall
down or topple over.
• If you have any questions, please contact our free
INOTEC service hotline at +49 7741 6805 777.
!
DANGER
Electrical voltage
Danger of death due to electric shock.
When switched on, electrical components can cause
uncontrolled movements and lead to serious injury.
1. Switch the machine off. To do this, turn the red rotary
switch to the horizontal position “0”.
2. Pull out the mains plug and finally disconnect the ma-
chine from the electrical supply.
12.2 Dismantling
Clean and dismantle the machine before sorting the parts
in compliance with the applicable occupational health and
environmental protection regulations.
12.3 Disposal
In accordance with the European Directive 2012/19/EU on
waste electrical and electronic equipment and its imple-
mentation in national law, this machine must not be dis-
posed of with household waste, but must be recycled in an
environmentally friendly manner!
The small silo inoCOMB Cabrio is mainly made of
high-quality metal. When you finally take the small
silo out of operation, note the following:
• Send the metal to a recycling facility.
• Dispose of the small silo via a scrap metal dealer or your
local scrap metal collection point.
Your used INOTEC equipment will be taken back by us and
disposed of in an environmentally conscious manner. Please
contact one of our service centres to arrange this.
