Ver. 3.604 (31/03/05)
p13
INNER RANGE IQ. PLUS Programmer’s Manual.
PROGRAMMING MULTI-DIGIT NUMBERS.
When programming any Multi-digit number, only one Address is selected regardless of the
number of digits to be entered.
Example.
To program the data “9 8 7 6 5 4 3 2” as the Primary Telephone Number.
1)
Enter Installer PIN code;
... .
2)
Press
, then the Address for the Primary Telephone Number
.
Any existing data will now be displayed as described above.
3)
Enter the new Data string
, then
4)
Select the next Address to program, or Exit Programming Mode.
4.5 “OPTION” DATA.
Option data is used to allow the Installer to select between two alternatives (Select/De-
select, Enable/Disable, Assign/Un-assign, etc.) for up to 8 Options or Items that relate to a
particular feature.
DISPLAYING “OPTION” DATA.
LED TERMINAL
Option Data is displayed on the Zone 1 to 8 Lamps on the LED Terminal.
When a Zone Lamp is ON, the option is Selected. (Enabled or Assigned)
When a Zone Lamp is OFF, the option is De-selected. (Disabled or Un-assigned)
LCD TERMINAL
Option Data Display
EDITING OPTION DATA.
Option Data is programmed by first selecting the Address of the Data to be edited in the
normal manner.
Any number of specific options are then Selected or De-selected by the following method:
1)
Check the current setting of the option on the Zone Lamps.
2)
For each option that needs to be changed, Press the option number
(1 to 8).
This procedure toggles the setting of the selected option.
i.e. If the option was De-selected, it will be Selected. If the option was already
Selected, it will be De-selected.
NOTE: On the LCD terminal the options are displayed as a series of letters, coresponding
to the name of each function (refer Section 9 Programming Reference). These
options are changed using the same keys as on the LED terminal, that is, keys 1-8.
3)
When all required changes have been made, press
.
To Select ALL available options:
Press
, then
.
To De-select ALL available options: Press
, then
.
Example. To Enable “Alarms” (Option 1), “Alarm Restores” (Option 2) and “Open
Report only after alarm” (Option 4) in “Dialer Options” (Address 506).
1) Enter Installer PIN code;
... .
2) Select the Address for Dialer Options. Press
,
,
,
.
The existing data will now be displayed as described above.
3) Enable the 3 options required. (Assuming none of the options already enabled)
Press
,
,
, (Zone Lamps 1, 2 and 4 should now be ON on the LED
Terminal and Y under option 1(A), 2(R) and 4(O) on the LCD Terminal ) then
.
LCD Terminal Before
LCD Terminal After
IMPORTANT NOTE:
Remember that the same key sequence is used to Disable an
option that is already Enabled.
Options YYYnnnnn
Dialler ARIOGo..
1 2 3 4 5 6 7 8
Options nnnnnnnn
Dialler ARIOGo..
Options YYnYnnnn
Dialler ARIOGo..
Options nnnnnnnn
Dialler ARIOGo..
