300
Appendix A
Figure 30-1: Configuration Modes and Bind and Link Commands Overview
30.2 SmartWare 2.0 Command Summary
30.2.1 Introduction
The SmartWare 2.00 commands are collected in configuration modes as illustrated in Figure 30-1.
Following all commands in the configuration modes are listed. The configuration modes are listed in
order as shown in Figure 30-1. The command summary is organized as follows:
Mode Name
Enter Command
Command
1
…
Exit
Mode
Name
…
Several commands contain a lot of parameters and arguments. The command syntax is described as
follows:
•
Arguments where you must supply the value are surrounded by <angle brackets>.
•
Optional arguments within commands are shown in square brackets ([ ])
•
Alternative parameters within commands are separated by vertical bars ( | ).
•
Alternative but required parameters are shown within grouped braces ({}) and are separated
by vertical bars ( | ).
Command Syntax is illustrated by an example in Figure 30-2.
Software Configuration Guide, Revision 1.03
