BOBCAT Hardware User’s Manual
Imperx, Inc.
Rev. 2.0.2
6421 Congress Ave.
11/20/2012
Boca Raton, FL 33487
+1 (561) 989-0006
215 of 265
MAOI MUST be enabled. All slave AOIs have to be positioned
within the MAOI. The slave AOIs can be set to be included or
excluded from the MAOI After enabling the selected AOI, the user
can enter the desired region of interest by setting the active window
size (Width, Height) and offset (X, Y). Image location (1.1) is top
left corner. The user can set the desired window size by typing the
numbers directly, or by selecting the desired size in the provided
gray square window. To do this enable the window first, press the
corresponding numerical number on the keyboard, and then draw the
window with the mouse in the gray square. Different AOIs will be
displayed with different colors.
5.7.8 Strobe Control
This window sets the camera strobe signals. Two independently controlled strobe
signals are supported – Figure 5.17.
Figure 5.17 – Strobe Control window
Strobe 1 Mode:
Sets the Strobe 1 mode of operation. The strobe can be disabled
or enabled. When enabled the strobe can be set to appear “Each
Frame”, “Odd Frames” only or “Even Frames” only. In addition,
in trigger mode, the user can add a strobe pulse associated with
rising edge of the trigger pulse.
Strobe 2 Mode:
Sets the Strobe 2 mode of operation. The strobe can be disabled
or enabled. When enabled the strobe can be set to appear “Each
Frame”, “Odd Frames” only or “Even Frames” only. In addition,
