CMN-91
Installation and Operation Manual
Operation
© 2016 Imagine Communications Corp. Proprietary and Confidential.
Revision D | Page 71
To enable the cursors for the selected display, press the CURS button. The Phase Cursor indications are
shown below.
Figure 37:
Establishing Cursor Select
To enable the Phase cursors
Press and release the CURS button.
Press the CURS button again to disable the cursor information.
When the cursor is selected, the Phase indication appears at the top of the display. Next to the Phase
indication is a numeric readout that indicates the difference between the REF and DELTA lines. The
active cursor (REF, DELTA, or both) is shown with small arrows at the outer end of the line.
To select a cursor line for control
1.
Press the curved arrow knob to select the REF or DELTA line to control. The REF line is the solid line,
and the DELTA line is the dotted line.
2.
Rotate the curved arrow knob to move the REF or DELTA line to the desired location.
3.
Press the curved arrow knob for the next cursor. Rotate the knob to move the cursor to the desired
location.
4.
Press the curved arrow knob a third time to control both the REF and DELTA lines.
5.
Repeat as necessary.
Once the cursors are no longer necessary, press and release the CURS button to disable the Phase cursor
selection.
To exit the cursor function while leaving the cursor active, press the VEC function button or select
another mode (that is, LINE, GAIN, or POS).
